Pinterest でおしゃれアイデアをまとめましょう!

関連トピックを見てみる

Modified Tool Holder by jjr2001 -- Here are a few of my favorite insert tool bits for the lathe: The first two on the left are shop made using 3/8" 1018 steel. Nothing special except that I like to put an insert on each end of the tool blank. With that config I can turn to a shoulder either left or right depending on the tool and then just remove and replace the tool holder on the 90 degree side of the tool post (parallel with bed) and the same tool (opposite end) will face the end of the...

Modified Tool Holder by jjr2001 -- Here are a few of my favorite insert tool bits for the lathe: The first two on the left are shop made using 3/8" 1018 steel. Nothing special except that I like to put an insert on each end of the tool blank. With that config I can turn to a shoulder either left or right depending on the tool and then just remove and replace the tool holder on the 90 degree side of the tool post (parallel with bed) and the same tool (opposite end) will face the end of the...

Set of tool makers mini jaws mounted on a 6" 3-Jaw chuck. This was my inspiration for the one I made and shown at http://www.homemadetools.net/mini-toolmaker-s-jaws

Set of tool makers mini jaws mounted on a 6" 3-Jaw chuck. This was my inspiration for the one I made and shown at http://www.homemadetools.net/mini-toolmaker-s-jaws

extrator de porcas e parafusos espanados stanley

extrator de porcas e parafusos espanados stanley

I made a set of v blocks to hold tapered stays. I copied the design from something I remember seeing on Flickr years ago.

I made a set of v blocks to hold tapered stays. I copied the design from something I remember seeing on Flickr years ago.

Pinterest
検索