Diy WeldingMetal Welding
Welding Torch
Welding DesignWelding ShopWelding CraftsMetal Projects
Welding ProjectsWelding IdeasAnother table, any tips? - WeldingWeb™ - Welding forum for pros and enthusiasts
I am making a welding table. I am going with a simple design. The top is 1/2 inch steel, 30 by 60. The frame is 2 inch 3/16 wall square steel tube. I will post pics as the project progresses. I was hoping to use my 110 mig 135 but im not sure it's up to the task, so i tigged it with miller 165 diversion. Im happy with the welds but any thoughts would be appreciated. The top was delivered and it had a 1/4 inch bow the short way. The long way it looked fine. I asked them to replace it, since i